Steroids
& Spot Injections
Butt
Injection
- What
size needle do I need?
- Will it hurt much?
- How to draw from a steroid vial
- The Injecting Procedure
- Miscellaneous
Tips
What size needle do I
need?
The smaller the gauge the larger the needle.
22 or 23 Gauge, 1.5 Inch is ideal for
injections into the glutes. 25 Gauge, 1.0 inch is ideal
for injections into the quads and can be used for all spot
injections. 25 Gauge, 5/8 inch
is often used for tricep/bicep/delts
Will it hurt much?
It hurts about as much as a good pinch, but that is all. After
the first couple of times you poke, you get used to it.
How to draw from a steroid vial:
***ALWAYS wash hands before injecting***
Wipe the top of the vial with an alcohol swab before the needle
enters - do this every time you pull the bottle out from storage
(do not blow on the top of the vial. Let the alcohol evaporate)
Pull back on the syringe approximately as much as you are going
to fill it (i.e. - if you are going to draw one cc then first
load one cc of air) poke the needle into the vial.
Inject the air into the bottle so that you have created a vacuum
effect and drawing will be easier
*Pull back on the plunger until the desired amount is achieved
(you may do this with the bottle upside down so that you can
'flick' the syringe to get the bubbles to settle while you are
still in penetration
*Once you have the amount you are looking for you will either
(A). be ready to switch needles or (B). you may leave the needle
on for pulling from another vial if you are going to mix
*So (A). you will pull back on the plunger once you are out of
the vial to get the remaining liquid out from the drawing
needle's base
*Poking the needle in to the vial dulls it. At this point you
may want to switch to a fresh (sharp) needle
You have now drawn from the vial.
Information provided by my #1 source
for pinz, www.GetPinZ.com
Injecting Procedure:
***Be careful not to touch the needle to ANYTHING. Think about
it, you are injecting deep in to your body. Any foreign
particles will be transferred deep in your tissue and you risk a
nasty infection.
*Get all bubbles out of the needle - flick it until they rise to
the top and then push them through the needle - make sure you
get them completely out of the needle as well - don't worry
about the juice dripping down the needle and don't even wipe it
as it makes for great lubrication
*In the injection spot - for glute you will look down on the
'cheek' and imagine splitting it into 4 quadrants, you would
inject into the upper most outer quadrant. For the leg, if you
were sitting down you will inject into the outer part of the leg
(but more on top, not on the side) where you have the most
'meat'
*Clean the site with alcohol and you are ready to inject
*Quickly pierce the skin and steadily push the needle into the
muscle. Push in smoothly until you have but a couple millimeters
left of the needle (you never inject all the way in as you want
to make sure some is still visible in case the needle should
break off and you need to retrieve it)
*Aspirate the syringe - pull back slightly on the plunger - you
will see one of two things. (A). You will see a couple small air
bubbles that when you stop applying pressure upward on the
plunger will readily go back into the muscle or (B). Droplets of
blood. (A) being the obviously favorable one. If there is blood
you must pull out, switch needles and start over.
*If all is well you may begin injecting. Push in slowly - you
will come to find that you can 'listen' to your body and it will
let you know how much it is willing to receive at once - when I
inject myself I apply consistent pressure to the plunger but I
go in only as fast or slow as my muscle wants to at that time.
Going too fast will potentially result in an abscess. When you
have completed this, wait a few seconds and then pull out and
take your alcohol swab and firmly press down and massage the
site to make sure everything stays in the muscle and the massage
will also prevent soreness in the morning. You may bleed just a
little bit, so it helps to tape the alcohol soaked cotton ball
to your injection site.
Miscellaneous Tips:
*If you are self-injecting, it helps to stretch out first. If
you are poking yourself on the right cheek, use your right hand
to poke, and support (under) the needle with your left hand. It
is not the easiest thing to do, but it can be done.
*When beginning, limit injections to 3 CC's at a time for glutes,
2 CC's for thighs and 1 - 1.5 CC's for all other spot injections
*Rotate injection spots. This will keep your receptors fresh. So
right glute, right delt, right leg, left leg, left delt left
glute - this will give you ample time off in between. Make sure
you dont hit an injection spot more than once per wk - you are
using 6 sites so you should be fine
Rotating injection sites will also keep you from building scar
tissue
*Injections are great after a shower so the muscle is relaxed
and it also helps to roll the syringe in your hand or run under
hot water to heat the liquid to make it easier on you.
***ALWAYS
wash hands before injecting ***
Information provided by my #1
source for pinz, www.GetPinZ.com
"Reliable
online steroid suppliers
can change everyday."
And this website
keeps up with those changes. The scammer list is updated
daily and news on our latest still reliable
suppliers are always kept current.
Thank you for
taking the time to visit my website. I've religiously
maintained this website for over 3 years now and you can count
that I'll still be at it whenever you're ready to buy steroids
online again. That's why you should
and tell your good gym buddies about it as well - besides,
what are good friends for anyway?
Thanks and the
best of luck to you!
|
